Sawyer Manufacturing Company
7799 S. Regency Dr., Tulsa, OK 74131 USA
F
918.834.0318
info@sawyermfg.com
P
918.834.2550
sawyermfg.com
V1.2
Installation
ADJUSTABLE TORCH ARM
1.
Mount bolts
(I)
to Quick Set machine.
(Fig. 1)
A. Place free floating spacer
(B)
onto bolt.
(I)
Note: Long threads thread into Quick Set machine not
short threads
Tip: Do not thread ¼” past opening
Installation
Operation
CAUTION:
Refer to manufacturers
settings for safety settings.
!
!
CAUTION
Fig. 1
2.
Mount torch arm assembly
(H)
to Quick Set machine.
(Fig. 2)
A. Use 2 washers
(I)
, & 2 9/16” nuts.
(A)
Tip: use 9/16” nut drive.
*Please refer to the Quick Set manual for installaton of the Quick Set machine*
I
Fig. 2
Fig. 3
Fig. 5
Fig. 6
Fig. 8
Fig. 9
Fig. 10
J
F
D
G
A
N
S
E
W
1.
Loosen and tighten adjustment knob to position assembly on and off
pipe/tube.
(Fig. 3)
Tip: This screw is to adjust free motion of torch arm.
*Please refer to the
Quick Set manual for
Operation of Quick Set*
Fig. 4
B
Fig. 7
Torch Arm Setup
1.
Adjust torch arm assembly.
(H, Fig. 5)
A. By loosening the 9/16” nut.
(A, Fig. 5)
Adjust torch arm
assembly
(H, Fig. 5)
to most southern point.
Note: For short barrel torches, you may need to move the torch arm
assembly halfway between north & south.
B. Tighten 9/16” nut.
(A, Fig. 5)
2.
Bevel angle adjustment.
(Fig. 6)
A. Loosen bevel indicator square nut.
(F, Fig. 7)
B. Adjust to desired bevel angle.
(Fig. 6)
C. Tighten bevel indicator square nut.
(F, Fig. 7)
Tip: Use ½” wrench.
3.
Position adjustment.
(Fig. 8)
A. Loosen position adjustment knob.
(D, Fig. 8)
B. Move assembly to desired position.
C. Tighten position adjustment knob.
(D, Fig. 8)
4.
Install torch inside torch holder.
A. Loosen torch adjustment knob.
(G, Fig. 10)
B. Install torch inside torch holder.
C. Tighten torch adjustment knob.
(G, Fig. 10)
Tip: For best cutting have a neutral flame
Open blow-through tab
te: Red hoses= fuel
E
H
H
