Thank you for purchasing this light fitting.
Please read the instructions carefully before use to ensure safe and satisfactory operation of this product.
Please retain these instructions for future reference.
Warning
Voltage:
240V 50Hz a.c.
Lamp:
2 x 15W T8
IP rating:
44
Specification
Layout
This product has special protection
against the ingress of moisture
and is manufactured to meet IP44
standards
This product is suitable for use in
Zone 2 and outside Zones of a
bathroom. See diagram.
If this unit is being fitted in
a room containing a bath or
shower, a 30mA RCD must be
used in accordance with IEE
regulations.
OUTSIDE ZONES
ZONE
2
ZONE
1
0.6m
0.6m
2.25m
Ceiling
500.0mm
490.0mm
660.0mm
700.0mm
55.0mm
This is a Class 1 product and must be earthed.
Please read these instructions carefully before commencing any work.
This unit must be fitted by a competent and qualified electrician.
Install in accordance with IEE Wiring regulations and current Building Regulations.
To prevent electrocution switch off at mains supply before installing or maintaining this fitting. Ensure other persons
cannot restore the electrical supply without your knowledge.
This light fitting should be connected to a fused circuit.
If replacing an existing fitting, make a careful note of the connections.
Always use the correct type and wattage bulb. Using the incorrect wattage bulb will damage the bulb and ballast.
When changing a bulb, always switch off at the mains and allow the old bulb to cool down before handling.
Dispose of used bulbs carefully and responsibly.
This product is not suitable for dimming.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling advice.
This product should not be fitted to PIR circuits or short duration timed switches. Should you wish to connect this
unit to a timed system please consult the manufacturer before installation.
Summary of Contents for 13937
Page 1: ...Reflex Mirror Light 13937 ...
