Commissioning
Instruction leaflet
Atlantis Post
70847 & 70848
www.saxbylighting.com
For your safety, always switch off the supply before changing lightbulbs, or cleaning. Live Voltages may be present in
this unit even when turned of or when completely disconnected.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Recycling advice
Safety information
Saxby Lighting Ltd. BH23 3PE
Do not use solvents or abrasive cleaners as these could
damage the finish.
In some cases, surface corrosion may arise after
installation. This is normally caused by tiny iron particles
left behind after the brushing process when finishing.
In normal circumstances, stainless steel is very resistant
to corrosion. It does however require maintenance to
preserve the high quality appearance. Wash the product
with warm soapy water, removing all surface deposits.
Rinse with clean water and with a soft cloth, wipe dry.
Then with a soft cloth soaked with a protective oil, wipe
all over.
If the product is subject to extreme environmental
conditions such as marine locations, industrial pollution
and acid rain these maintenance procedures should
be carried out around four times a year. For severe
corrosion, non-abrasive cream cleaners or proprietary
stainless steel cleaners should be used to remove the
corrosion. Wash and dry as detailed above. Then with a
soft cloth soaked with a protective oil, wipe all over.
Do not clean the units with a pressure washer.
- Fit the product over the fixing bolts, re-fit the plastic
washers (B) and then the dome nuts (A). Use a
suitable spanner to securely tighten the product to
the mounting surface.
- Replace fuse or circuit breaker and switch on. Your
light is now ready for use.
Iss.1 27052016
Fitting/replacing bulbs
• When changing a bulb, always switch off at the
mains and allow the bulb to cool before handling.
Dispose of used bulbs carefully. Do not exceed the
wattage stated or use a different shape bulb from that
indicated on the fitting.
1. Unscrew the bezel
2. Remove the old bulb by turning anti-clockwise.
3. Insert new bulb.
4. Replace the bezel ensuring that it is tightly secured.
•
You have correctly identified the wires.
•
The connections are tight.
•
No loose strands have been left out of the connection block.
Check that...
Care & Cleaning
