Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and
satisfactory operation of this product. Please retain these instructions for future reference.
Warning
This light fitting is Class 1 and must be connected to
an Earth circuit
Please read these instructions carefully before
commencing any work.
This unit must be fitted by a competent and qualified
electrician.
Install in accordance with IEE Wiring regulations and
current Building Regulations.
To prevent electrocution switch off at mains supply
before installing or maintaining this fitting. Ensure
other persons cannot restore the electrical supply
without your knowledge. If you are in any doubt,
please consult a qualified electrician.
This light fitting should be connected to a circuit with a
30mA RCD fitted.
If replacing an existing fitting, make a careful note of
the connections.
Always use the correct type and wattage bulb. Using
the incorrect wattage bulb will damage the bulb and
ballast.
When changing a bulb, always switch off at the mains
and allow the old bulb to cool down before handling.
Dispose of used bulbs carefully and responsibly.
Waste electrical products should not be disposed of
with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for
recycling advice.
This product is rated at IP65.
This product is not suitable for dimming.
This product is not suitable for location in or near a
marine or sea environment.
The entire unit gets hot whilst on for a period of time.
Specification
Voltage:
240V 50Hz a.c.
Lamp:
2 x 35W GU10 halogen
IP rating:
65
Layout
Installation
Wiring
• Plan the desired layout of this fitting carefully,
ensuring the cables will reach the distance between
the junction box and the light fitting.
• This product is designed for domestic and light
industrial use. It should not be used to support other
objects or used as a replacement for concrete or
metal pillars.
• Avoid locating any cables in positions that would
cause a hazard. Position cables and outdoor rated
junction boxes (not supplied) away from areas
where they may be at risk from being cut, trapped or
damaged.
• We recommend that you use H05RN-F specification
cable (not supplied) which is an outdoor grade,
rubber sheathed cable. The mains supply cable must
have a minimum cross sectional area of 1.0mm².
Existing fittings must be completely removed before
installation of a new product. Before removing the
existing fitting, carefully note the position of each set
of wires.
- Using base plate as a template, mark the fixing holes
onto the mounting surface.
- Drill holes to the necessary size and depth - taking
care not to damage any concealed pipes or wiring
below the mounting surface.
- This product comes complete with expanding
bolt type fixings (C) which are suitable for use on
most surfaces, however alternative fixings may be
required.
- Push the fixing bolts into the mounting holes.
Having correctly identified the wiring from
your existing light fitting, pull the wire through
the bottom of the fitting and connect to the
connection block inside the product in the
following way:
•
See Diagram 2. Pull spacing strip from
inside of tube.
•
Unscrew the 4 screws which attach the
black box to the spacing strip. Open
the terminal block case and pull out the
terminal block. Wire as detailed below.
•
Push terminal block back into the black box
and refit the terminal block cover.
NEUTRAL
EARTH
SWITCHED LIVE
BLUE (N)
BROWN (L)
GREEN/YELLOW
SUPPLY
LIGHT FITTING
