Instruction leaflet
Equinox Bollard
49911
www.saxbylighting.com
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Recycling advice
Safety information
Saxby Lighting Ltd. BH23 3PE
This bulb is protected by a shade. This part must be replaced immediately should the shade become
cracked or damaged. This fitting must not be used without the shade in place.
Replace Cracked
Shade
Iss 2 27032014
When changing a bulb, always switch off at the mains
and allow the bulb to cool before handling. Dispose of
used bulbs carefully.
Do not exceed the wattage stated or use a different
shape bulb from that indicated on the fitting.
To access the bulb, simply unscrew the shade. Unscrew
the old bulb from the lampholder and replace with a new
one. Then screw the shade back in place.
Fitting/replacing bulb
Commissioning
• Push the terminal block up into of the tube.
• Stand the product in place inline over the mounting
holes and use a suitably sized screwdriver to tighten
them so that they hold the fitting securely to the
mounting surface.
• Replace fuse or circuit breaker and switch on. Your
light is now ready for use.
Care and Cleaning
23W ES Energy Saver
Do not use solvents or abrasive cleaners as these could
damage the finish.
In normal circumstances, stainless steel is very resistant
to corrosion. It does however require maintenance to
preserve the high quality appearance. Wash the product
with warm soapy water, removing all surface deposits.
Rinse with clear water and with a soft cloth, wipe dry.
In some cases, surface corrosion may arise after
installation. This is normally caused by tiny iron particles
left behind after the brushing process when finishing.
Wash and dry as detailed above. Then with a soft cloth
soaked with a protective oil, wipe all over.
However if the product is subject to extreme
environmental conditions such as marine locations,
industrial pollution and acid rain these maintenance
procedures should be carried out around four times a
year. For severe corrosion, non-abrasive cream cleaners
or proprietary stainless steel cleaners should be used to
remove the corrosion. Wash and dry as detailed above.
Then with a soft cloth soaked with a protective oil, wipe
all over.
Glass parts - Remove and wash in warm water or just
use a damp cloth. Do not use abrasive materials as
these will damage the finish. Glass parts - Remove and
wash in warm water or just use a damp cloth. Do not
use abrasive materials as these will damage the finish.
Do not clean the units with a pressure washer.
