www.saxbylighting.com
Instruction manual
59136, 59138
IkonPRO RGB LED Kit
We recommend cleaning with a soft dry cloth. Do not use solvents or abrasive cleaners as these could damage the finish.
Care and Safety
Technical data
RF Control
220-240V~, 50Hz
Supply
Voltage:
Bulb
Type:
59136----10 x 0.75W LED module, RGB
59138----10 x 1.5W LED module, RGB
The power supply is Double Insulated and does not require connection to an Earth circuit.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or local store for recycling advice.
This product is suitable for dimming with remote control.
This product is rated at IP67.
IP
67
Class III product - designed to be supplied from a SELV
(Separated or Safety Extra-Low Voltage) power source.
Output: 12V DC 15W Max. Constant voltage
To prolong the life and condition of the product, it is recommended that periodically it is cleaned using a
soft cloth followed by the application of a light coating of oil, such as WD40.
Do not clean the units with a pressure washer.
Conformity with all relevant EC Directive requirements.
Conformity with all relevant UKCA Directive requirements.
Live Voltages may be present in the transformer even when turned off or when completely disconnected.
For your safety, always switch off the supply before maintaining the system.
V6 26/11/2021
EU Manufacturer:
Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg
UK Manufacturer:
BH17 7BY
RGB
Decrease
Brightness
On / Off
Button
Increase
Brightness
Function Control
Button
The LED module of this luminaire is not replaceable, when the LED module reaches its end of life the whole
luminaire shall be replaced
Push the plug into the mains socket and switch on.
Slide the battery cover off the RF controller and fit the battery
observing the correct polarity markings.
Press the On / Off button on the RF controller. The red LED should
light at the top, and the signal LED should light on the power supply.
Push the RGB button to switch between the different colours. There
are seven individual colours and then two variable modes.
The fixed colour sequence is yellow, white, red, green, blue, purple
and light blue.
There are two variable modes. One switches between all seven
colours and the other fades between them.
The sequence will repeat from the start.
