www.saxbylighting.com
Instruction manual
67176, 67177
Lucca Wall
Photocell Sensor (only for 67177)
• This product is fitted with a photocell.
• The light will automatically switch on when the ambient light level drops below
30 lux
and will automatically switch off
when it reaches
70 lux
.
• The photocell is located on the right hand side of the casing. To avoid nuisance triggering, the photocell should be
aimed
a minimum of 12m
away from heat sources, such as BBQ’s, Air-Conditioners, other outside lighting, moving
cars and flue vents or reflective surfaces such as smooth white walls or swimming pools.
V4 07/06/2022
EU Manufacturer: Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg
UK Manufacturer: BH17 7BY
Technical data
220-240 V~, 50 Hz
Supply
Voltage:
We recommend cleaning with a soft dry cloth. Do not use solvents or abrasive cleaners as these could damage the finish.
For your safety, always switch off the power supply before cleaning.
Care and Safety
This light source is protected by a shade. This part must be replaced immediately should the shade
become cracked or damaged. This fitting must not be used without the shade in place.
Replace Cracked Shade
Conformity with all relevant EC Directive requirements.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or local store for recycling advice.
This product is rated at IP65.
IP
65
This product is not suitable for dimming.
Conformity with all relevant UKCA Directive requirements.
For further information, please visit
https://www.lighting-info.co.uk/67176
Bulb
Type:
This product contains a light source of energy efficiency class
E
.
30W LED module (SMD), 4000K
Non-replaceable control gear
Non-replaceable light source
This product is Class 1, must be connected to earth.
