• The LED's in this product are non replaceable.
Instruction leaflet
Panther Wall
52016
www.saxbylighting.com
Under no circumstances must the connecting lead be modified for use as a power lead. This would make the
exposed input socket live. For your safety, always switch off the supply before cleaning.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Recycling advice
Safety information
Saxby Lighting Ltd. BH23 3PE
We recommend cleaning with a soft dry cloth.
Do not use solvents or abrasive cleaners as these could
damage the finish.
Fitting/replacing bulbs
Iss.2 20112015
• Refit to front cover to the product using the supplied
screws.
• Replace fuse or circuit breaker and switch on. Your
light is now ready for use.
Commissioning
• Please note that the unit will not illuminate in
emergency mode until the mains has been switched
on and subsequently failed.
• Restore the mains supply for at least 30 minutes and
then turn it off. The LED lamp should illuminate for at
least 30 seconds.
• Switch on the Mains Supply and note the indicator
LEDs on the side of the unit have illuminated. This
indicates that the unit is operating correctly e.g. the
lamp continuity is correct and that the battery is being
charged.
• The unit has built in High Discharge Protection and
this should operate when the battery voltage fails to
approximately 8V DC, whilst in emergency mode
Operational check
Care and cleaning
