T
ELESCOPE
ASSEMBLY
F
INDERSCOPE
A ASSEMBLY
E
YEPIECE
A ASSEMBLY
4
12.
INSERTING EYEPIECE (12)
1) Loosen the thumbscrew on the end of
the focus tube.
2) Insert diagonal into focus tube and re-tighten
thumbscrew to hold diagonal in place.
3) Loosen the thumbscrews on the diagonal.
4) Insert the desired eyepiece into diagonal and
secure by re-tightening thumbscrews.
ATTACHING THE FINDERSCOPE
BRACKET (11)
1) Locate finderscope optical assembly.
2) Slide finderscope bracket into the rectancular slot and
tightened screw to hold mount in place.
11.
ATTACHING THE RUBBER-O-RING (10)
1) Locate finderscope bracket. Carefully remove
the rubber-o-ring from the finderscope bracket.
2) Position o-ring into groove located approximately
half-way along the finderscope tube.
10.
ATTACHING THE TELESCOPE
MAIN TUBE TO TUBE RINGS (9)
1) Remove the telescope tube from the paper covering.
2) Find the center of balance of the telescope tube. Place this
in between the two tube rings. Close the hinges around the
telescope and fasten securely by tightening the thumb nuts.
ATTACHING THE TUBE RINGS TO MOUNT(8)
1) Remove the telescope tube from its plastic packaging.
2) Remove the tube rings from telescope by releasing
their thumb nuts and opening their hinges.
3) Using the bolts provided, fasten the tube rings to the
mount with the 10mm wench provided.
8.
9.
