35
When the line is on hold, “CALL ON HOLD” appears on all
the handsets and base unit display.
Press [HOLD] key again or [Talk] key to release.
Note :
The call can be picked up by the base unit or any handset registered to the sam e
base unit by pressing the
or [Talk] key.
SENDING TONE SIGNALS IN PULSE DIALING MODE
If your telephone line uses pulse dialing (such as for a rotary dial phone), you can temporarily
override the Pulse M ode setting with the Tone M ode until the unit goes back on-hook. This may
be necessary to access certain special services such as bank-by-phone services:
1. Use pulse dialing to call the service.
2. W hen the service answers, press [
].
3. Follow the normal procedure for the special service you are using. Any additional
num bers you dial are sent as tone signals.
4. W hen you hang up, the telephone returns to pulse mode.
DIAL VOICE MAIL
If you have subscribed to the Voice Mail and Message W aiting Indicator services, you
can access your voice m ail system by pressing [DIAL V.M.]. To use this feature, you
m ust first program your voicemail access num ber into the handset and base unit.
Program your own Voicemail access number
Press the [DIAL V.M.] softkey.
Press the [EDIT] softkey to add your access num ber.
Enter your access number. If you m ake a m istake,
press [DELETE] to erase the last digit and re-enter.
Press [SAVE] to confirm programming.
You are now ready to use the
Dial voicemail
key.
CALL ON HOLD
HOLD
DIAL VOICE MAIL
╴
EXIT
SAVE
DIAL VOICE MAIL
1234567
USE OK = DIAL
EDI
T O.K.
EXI
T
SAVE
AD VAN C E D OP E R AT ION
