9
To disconnect one of the parties:
Press the
LINE
button of the person you want to continue talking to, and the
other party will automatically be disconnected.
To disconnect both parties:
Hang up the handset, or press
SPEAKER
.
NOTE: If you have two lines on hold, and you want to conference with both
parties, simply press the
CONFERENCE
button and pick up the handset or
press
SPEAKER
button. To put both parties on hold, press the
HOLD
button.
To speak to one party individually, press the
HOLD
button, then press the line
of the party to whom you want to speak (the second party remains on hold.) If
the speakerphone indicator is off and you are using the speakerphone, press the
SPEAKER
button to continue the conversation on the speakerphone.
MUTE Function
Pressing the
MUTE
button turns off the telephones microphone so that the other party
cannot hear you, but you can hear them. Pressing the
MUTE
button again restores
connection to the microphone so the other party can again hear you. The LCD will
display “MUTE” while the function is active.
FLASH Button
If you subscribe to “Call Waiting” (a special telephone service) the
FLASH
button is
used to connect the line to another incoming call or to establish a dial tone to make
another call while still connected to the initial caller.
Note: If you do not subscribe to Call Waiting, pressing the
FLASH
button during a call
will disconnect the current call.
Pause Function
Use this function when a delay is needed in an automatic dialing sequence. For
example, when you must dial a 9 to get an outside line or when you enter codes to
access your long distance company. A pause may also be stored in AUTO DIAL and
other memory dial entries.
Phone Book Function
You can store 70 numbers and names in the phone book, refer to the “FUNCTION
OPERATIONS”, under the “PHONEBOOK” section for details.
HEADSET Function
To use a headset, connect a headset with a 2.5mm connector into the headset jack. To
make a call, press the
HEADSET
button. A dial tone will be heard on the headset and
the phone may be dialed. To end the call, push the
HEADSET
button again.
Volume Function
The volume level of the handset, headset and speakerphone can be set using the
volume
+
and
-
buttons. To adjust, go off-hook with either the handset, headset or
speakerphone. The LCD will display the volume setting information as it is adjusted.
Ringer Volume Switch
Set the ringer volume switch to the desired position (HI/LOW/OFF). To have the maximum
ringer volume, move the ringer volume switch to the HI position. To have a low ringer
volume, move the ringer volume switch to the LOW position. If you would prefer the
ringer not to disturb you, move the ringer volume switch to the OFF position.
Functions
