17
[Note]
Model
SBS-600
uses only 6 * AA, 1.5V Alkaline battery - Non Rechargeable Battery.
Model
SBS-700
uses only the supplied 7.2V NiMH Rechargeable Battery Pack.
When Battery low signal is blinking, In the model
SBS-600
, replace with New AA Alkaline
battery cell as soon as possible. In the model
SBS-700
, recharge the battery pack as soon as
possible.
If Battery is completely depleted, and needs to be replace with a new battery, please replace
battery using the following procedure.
①
Remove the Holster Case from the Meter.
②
Remove Battery Cover from the Rear Case of the meter.
③
Replace Battery and be sure to connect correct polarity inside the battery compartment.
④
Close Battery Cover and assembly in reverse order of above when opening Battery
Compartment
Battery Charge
(model
SBS-700
only)
.
Do not discharge battery with reverse polarity.
Do not use any other Rechargeable Battery. Use only the 7.2 V NiMH battery pack supplied
from original manufacturer.
Connect the Battery with the proper polarity.
When charging the battery, use only the AC Adapter and Internal charger supplied from the
original manufacturer.
Please follow Battery Charging procedure.
①
Connect the DC Power adapter to Power Outlet.
②
Plug charging connector into the
SBS-700
.
③
When Charging is completed, “FULLY CHARGED”
message is displayed on the screen.
④
If Battery is fully charged, disconnect DC Power Adapter.
⑤
Do not charge Battery while meter is being use
Fuse Replacement
If the Fuses open due to fault, Replace fuses using the procedure below ;
①
Power off the Meter. Disconnect Test Lead from Meter.
②
If DC power adapter is connected, disconnect the adapter from the meter.
③
Separate Battery Cover from meter.
④
Pull out one end of defect Fuse from Fuse Clip.
⑤
Replace with same size and rating Fuse. Fuse should be placed in center of Fuse Clip.
⑥
Do not touch any other component besides Fuse.
⑦
Assemble the Battery Cover to the meter
⑧
Fuse Ratings and Dimensions are as below ;
[Fuse Rating and Dimensions]
500mA/250V 5mm × 20mm (FF)
1OA/250V
6.3mm × 32mm (FF)
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
