3
[WARNING
]
Pay attention when testing conditions exceed 60V DC, 30V AC rms or 42.4V AC Peak that can
cause an electric shock. Do not connect the Ground wire to voltage higher than 0V DC, 30V
AC rms or 42.4V AC Peak.
Use only the proper accessories supplied with the meter. Rechargeable Battery Pack, AC
Power Adapter and Internal Charger, Test Lead, Probe, Logic/Signal Cable set. Warranty
will not cover Meter Measurement failure or damage from improper accessories other than
supplied by manufacturer of the Meter.
Connect and disconnect properly. Connect Test Leads, Probes or Cables to the Meter before
connecting to the active circuit to be tested. Disconnect Leads, Probes or Cables from the test
circuit prior to disconnecting them from the meter.
Testing Probe always connected with Testing Circuit in series
.
Replace the Ni-MH Battery Pack only with an equivalent from the Manufacturer. Remove
AC Power Adapter, Test Lead, Probe and Cable from Meter when replace the Battery.
When the Battery Warning Symbol is blinking on the display, the measurement may display
in error. Recharge the battery or replace.
Observe all terminal ratings. Observe all rating and marking oin the Meter. Refer to
Operator manual for detailed information.
[
Max Input Voltages]
- Scope Input: 300V CAT
Ⅲ
.
- Meter Input: 600V CAT
Ⅲ
.
Do not apply any voltages when measuring OHM (resistance) or Capacitance for the Meter
Mode.
Do not use Meter where in or near explosive, flammable, wet or damp environments.
Do not use Meter with the Case Cover open for any reason.
Fuses should only be replaced with the proper size and rating as specified in the manual.
Do not expose circuit.
[ATTENTION]
Before testing in Resistance, Capacitance, Continuity or Diode modes, disconnect any
power supply to the circuit being tested and discharge High Voltage Rated Capacitance.
Do not attempt Voltage measurement while measuring Current.
[ENVIRONMENT]
The Meter is designed Indoor use in following environment conditions
Operating Temperature: 32°F - 122°F (0°C ~ 50°C)
Guaranteed Accuracy Temperature: 73.4°F +/- 41°F (23 0°C +/- 5°C)
Operating Humidity: 80% R.H. or less
Storage Temperature: 32°F - 158°F (0°C ~ 70°C)
Altitude : 2000m
CAT III 600V Pollution Degree : 2
