5
Preparation of the stove for
rear discharge to a brick-built
chimney
Scan 60 and 61: we refer to the specific instructions for
these stoves.
1. Remove the cover
plate on the rear of the
stove.
3. Remove the inner cover
plate (cooking ring) with the
hexagon spanner. The cook-
ing ring is to be put in the top
outlet (for models with a dou-
ble-steel top plate, you must
first mount an intermediary
ring). Remove the ceramic
gasket from the cooking ring
and place it in the top outlet
without fixing it).
4. Fit the flue collar from
the outside into the dis-
charge hole of the com-
bustion chamber in such
a way that the bracket
is located on the inside.
Tighten the screws.
Scan 4 and Scan
ANDERSEN stoves are
equipped with a heat
shield at the rear (Fig.
2). The rear outlet is
punched in the plates.
Remove the two punched
plates and continue on
fig. 1, ill. 3-4.
You can also connect your stove with a top outlet and a 90-
degree elbow into the chimney.
The stove is prepared in the same way as a direct connec-
tion to a steel chimney (see page 6).
2. Cut free the inner
plate with a pair of nip-
pers
Fig. 1 (1-4)
Fig. 2
Fig. 3
M O U N T I N G I N S T R U C T I O N S
Top outlet and elbow