A S S E M B LY
8
1
6
0
m
m
Connection with 90° elbow pipe (top outlet)
If you intend to use a 90° elbow pipe to connect the wood-burning
stove, the cleansing lid on the elbow pipe must be in the vertical sec-
tion of the pipe to allow cleaning of the horizontal section through
the access cover.
Connection for rear/side outlet
For installation through rear or side walls, we recommend a 2x45°
elbow pipe with cleansing lid to facilitate cleaning of the smoke gas
pipe. Keep a distance of 160 mm between the center of the rear/side
outlet and the bottom of the elbow pipe.
Cover plate top outlet
Cover plate rear/side
connection
Flue pipe max. Ø195
Flue pipe max. Ø275
Connection between stove and steel chimney
Your Scan dealer, or local chimney sweep, can advise you on choosing
a make and type of steel chimney. This ensures that the chimney
will match your wood-burning stove. As a general rule, the length of
the flue should not be less than 3.5 m measured from the top of the
wood-burning stove.
Choosing the wrong length or diameter of steel chimney could
impair functionality.
Always observe the chimney vendor’s instructions precisely.
Requirements for chimney
The chimney must be labeled T400 and G for soot testing.
Preparing the stove for top/side/rear outlet
To connect the flue pipe, remove the required cover plate as follows:
1.
Use the tools provided (see service package) to remove the cover
plate at the rear of the wood-burning stove.
2.
Tilt the cover plate back and forth a number of times to loosen
the plate before removing it.
Flue pipe max. Ø
240