4
REVERSING THE DOOR HINGE
The door can be opened from left to right and vice versa. Should
you wish to change the opening direction, please follow these in-
structions.
Note: all parts removed should be kept safely. You will require
these for the reinstallation of the door.
•
Remove the two screws (1) that hold the upper hinge (5)(right
side) to the frame.
•
Lift the door off and place on a padded surface to prevent
scratching.
•
Remove the blanking plug (8) from the hole in the upper left
corner of the door and transfer it to the uncovered hole on
the upper right corner. Press firmly to secure it.
•
Remove the two screws (6) that hold the lower hinge (2)
•
Remove the adjustable front left foot and transfer it to the
other side.
•
Remove the bolt pin(7) from the lower hinge (2) and reverse
the direction of the lower hinge. Secure the lower hinge (2) to
the left side of the lower frame with the two screws (6) Re-
insert the bolt pin (7). Set the door into position, making sure
it is seated comfortably onto the lower hinge (2).
•
Holding the door closed, secure the upper hinge (5) into the
top frame with the two screws (1). Check the door is level and
tighten the screws firmly.
Fig 1 Position of components prior to reversal of the door hinge.
Fig 2 Position of components after reversal of the door hinge.
BEFORE USING FOR THE FIRST TIME
•
The appliance may be placed with its rear panel at a distance
of at least 10 cm away from the wall to allow air circulation.
•
Your
refrigerator
should be placed on flat and firm surface for
quieter operation.
•
Do not expose the appliance to direct sunlight or a heat
source such as ovens, radiators, heaters, etc.
•
Do not under any circumstances place heated beverages in
your
refrigerator
.
•
Do not open the door more often than necessary to lessen the
escape of cold air.
•
For better air circulation, do not overfill the unit.
•
Adjust the temperature regulator according to the amount of
product and the ambient temperature.
Thermostat
The digital display controls the entire fridge.
- The temperature in the fridge is determined by the setting of
the digital thermostat.
-Insert the plug into the wall socket.
- When you use the refrigerator for the first time
press "SET" key. The display will blink
after which you set the desired temperature. The temperature
you can change by entering the keys to the left of the display
push-buttons, key up or key down.
- When the temperature has already been set and you want this
changed, then key in "SET". Change the temperature indoors
10 seconds after you have pressed the "SET" key.
- After inserting the plug into the wall socket
the compressor will start after about 3 minutes.
- Place the products in an orderly manner in the fridge.
WARNING
If temperature selector is set to too low a setting, drinks become
frozen. In extreme circumstances, glass bottles may even break.
Always exercise caution when setting the temperature.
•
Do not place heavy items (more than 20kg) on top of the
re-
frigerator
.
•
Do not place any items on top of the
refrigerator
which may
fall off when the door is opened.
•
After the appliance has been unplugged, leave for three mi-
nutes before plugging it in again.
When not in use If the unit is not being used for long periods:
•
Unplug your
refrigerator
.
•
Clean and dry the inside of the appliance. Leave the door
slightly open to allow it to dry completely.
•
A cooler which is unused without being cleaned may start to
smell musty or develop mildew.
Summary of Contents for DKS142
Page 1: ...2 ENG...
