TRANSPORTATION
AND
INSTALLATION
INSTRUCTIONS
TRANSPORTATION
：
1. When you transport the freezer, the an-
gle between the compartment body and
the ground should be no more than
45°and you should never place the
freezer up-side down.
2. Do not use any of the external part as
loading points, for example, the conden-
ser on the back, the door.
INSTALLATION
：
1. When the freezer is installed or used, all
the package (including board and foam
plastic) should be got rid of.
2. Keeping the freezer stable to avoid vi-
bration and noise.
3. The freezer should be installed in the
place with good ventilation, a space of
at least 10cm should be allowed be-
tween the surrounding walls and the
cabinet wall for air condition.
4. It should be placed far from heating re-
source and not under direct sunshine to
avoid decrease of the efficiency of re-
frigeration.
5. Install the freezer in a dry place so as to
prevent rust on the compartment body,
which may affect the electric insulation.
•
WARNING:
When positioning the appli-
ance ensure the supply cord is not
trapped or damaged.
•
WARNING:
Do not locate multiple port-
able socket-outlets or portable power
supplies at the rear of the appliance.
OPERATING YOUR
FREEZER
POWER SUPPLY
The power supply should always be in ac-
cordance with the rating plate on the back
of the freezer; here you can read the voltage
(V) and frequency (Hz). The power supply
must always be in accordance with the law
and regulation of the country with regards
to electrical safety. If you are in doubt ask
your supplier.
STARTING UP
If the compressor does not start when the
freezer has been plugged in , then the power
supply of the unit is not in order . Check if
there is electricity running from the power
socket to the plug or if the fuse is blown.
THE FUNCTION OF CONTROL
PANEL:
A: Nick
B: Green Light
C: LED Switch
(Optional)
1. The figure on the temperature control
1~7 only means the temperature level
from high to low, not means the specific
temperature.
2. The green light is a power indicator,
when it is on, the power is connected.
3. We need to use a special tool (for exam-
ple, a flat-blade screwdriver) to turn the
knob till the nick pointing to a specific
figure (1~7).
4. Turn the knob clockwise, the tempera-
ture inside will go down, turn the knob
