1
Warning: Risk of fire / flammable materials
Transportation and Placement
△
When transporting the freezer showcase from one place to another, the inclination of the cabinet should not exceed 45
degrees, for prevention against compressor or system damage.
Before use, remove all the packing material. The back side of the refrigerator should be placed to face to the wall and
more than 20cm away from the wall, both flank sides more than 20cm. Please prevent people touch hazardous
components of the back.
The freezer should be put in well-ventilated, dry place. Don’t use it under direct sunshine. The freezer should be kept
away from water sink, heat source and any volatile, corrosive material.
If the equipment cannot be used anymore, please do not throw it away freely, it is necessary to be sent to a qualified
organization for further professional disposal.
Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
Power source and test-running
Single-phase power supply, 50Hz, voltage range 220~240V. If the voltage is unstable, please install a voltage stabilizer
with capacity above 1000W.
Avoid turning on and off the power too frequently. If the power is turned off, wait an interval of 5 minutes before turning
it on again.
When the freezer will be out of use for a long time, disconnect the power first, then clean it. Please examine the circuit
whether it is excellent before reuse.
Operation of the Temperature
When screen shows “E0”, This means problem of the temperature sensor.
The screen shows the temperature inside.When compressor runs, the mark “
*
” shows on the screen.
When compressor stops or the freezer make auto defrosting the mark “
*
” flashed.
1.Normal temperature setting.
1.1
Press the key
“
temperature -
”
and
“
tempe
”
together for 3 seconds,the screen shows
“
ST
”
, press
the key
“
switch/set
”
, the screen shows the setting temperature.
1.2
Press the key
“
temperature -
”
to decrease the temperature, press the key
““
tempe
”
to increase
