Water Supply And Drain
Cold water connection
Connect the cold water supply hose to a threaded 3/4(inch)
connector and make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended
period of time, let the water run to make sure that the water is
clear. This precaution is needed to avoid the risk of the water inlet
to be blocked and damage the appliance.
About the safety supply hose
The safety supply hose consists of the double walls. The hose's system
guarantees its intervention by blocking the flow of water in case of the supply
hose breaking and when the air space between the supply hose itself and the
outer corrugated hose is full of water.
Warning
A hose that attaches to a tap can burst if it is installed on the same water line as the
dishwasher. If your sink has one, it is recommended that the hose be disconnected and the
hole plugged.
How to connect the safety supply hose
• Pull the safety supply hoses completely out from storage compartment located at rear of
dishwasher.
• Tighten the screws of the safety supply hose to the faucet with thread 3/4inch.
• Turn the water fully on before starting the dishwasher.
How to disconnect the safety supply hose
• Turn off the water.
• Unscrew the safety supply hose from the faucet.