© Scania Industrial & Marine Engines
5
CERTIFIED ENGINES
An emission certified engine has been approved according to a specific
certification standard. The certified engines delivered by Scania meet the
most compelling emission standards in the European (EU) and non-European
(USA) markets.
Scania guarantees that all engines of a certified engine type that are delivered,
correspond to the engine approved for certification.
The engine is fitted with a certification plate, stating according to which
certification rules (standard) the engine has been approved. Refer to page 10.
The following is required for the engine to meet the emission standards after
being commissioned:
- Service and maintenance must be performed according to this
Operator’s Manual.
- Only genuine Scania parts must be used.
- Service work on the injection equipment must be performed by an
authorized Scania workshop.
- The engine must not be modified with equipment not approved by
Scania.
- Seals and setting data may only be broken/modified after approval by
Scania, Södertälje. Changes should only be made by qualified
personnel.
- Changes affecting the exhaust system and intake system must be
approved by Scania.
Otherwise, follow the instructions in this manual for operation, care and
maintenance of the engine. Also observe the safety precautions described in
the following four pages.
Important!
If service and maintenance are not performed as stated
above, Scania cannot guarantee that the engine corresponds
to the certified configuration and will not assume liability for
any damage occurring.