78
Instrucciones de uso
|
SCANIA Interlock
®
7x00
|
Mantenimiento
7 Mantenimiento
7.1 Calibración/ajuste
●
A realizar solamente por un Centro de Servicio Autorizado Dräger-Interlock.
●
Comprobar la calibración cada año como mínimo.
●
Después de transcurrir el intervalo de servicio, en la pantalla aparece el
mensaje
Servicio requerido
en
X
días
.
●
Si el aparato no se somete al mantenimiento, el vehículo puede continuar
arrancándose durante un período de transición de varios días (en función
de los parámetros ajustados).
7.2 Limpieza
●
Para la limpieza, frotar el aparato con un paño de un solo uso.
●
¡No sumergir el aparato en líquidos, evitar que algún líquido pueda entrar
en contacto con las conexiones!
8 Eliminación
Eliminar el producto según las normativas en vigor.
9 Características
técnicas
Para obtener información sobre los detergentes y desinfectantes ade-
cuados y sus especificaciones, véase el documento 9100081 en
www.draeger.com/IFU
.
Este producto no debe eliminarse como residuo doméstico. Por este
motivo está identificado con el símbolo contiguo.
Dräger recoge el producto de forma totalmente gratuita. La información
a este respecto le puede ser proporcionada por los distribuidores nacio-
nales y por Dräger.
Principio de medición
Sensor Dräger electroquímico
Rango de medición
hasta 3,0 mg/L
Condiciones ambientales
Durante el servicio y el
almacenamiento
de -40 a 85 °C
de 20 a 98 % h. r.
de 600 a 1.100 hPa
Los cambios de altura no influyen en el resul-
tado de medición
Deriva de la sensibilidad
generalmente 1 % del valor medido/mes
Indicación
Pantalla
Intervalo de calibración
típico 12 meses
Dimensiones (Al x An x Fon)
Dispositivo manual
aprox. 138 mm x 61 mm x 36 mm
Unidad de control
aprox. 148 mm x 90 mm x 32 mm
Peso
Dispositivo manual
aprox. 240 g
Unidad de control
aprox. 240 g
Alimentación de tensión
de 12 a 24 V
Consumo de corriente
Máximo
<2,5 A
En funcionamiento
<1 mA
Relé de conmutación para el cable del relé de arranque
continuo
<16 A
pico
<40 A