Multistripper mini – Manual
- 13 -
Scanmaskin has planned maintenance and repair works for the Multistripper mini. Only the activities
that have been described below can be applied.
When doing so, it is imperative to keep the default and the described procedures. The application
of original spare parts guarantees the dependable utilization of the machine in the future.
The following works have been planned:
•
Cleaning (chapter 7.2)
•
Changing the blade (chapter 7.3)
7.2 Cleaning and maintenance
Caution
!
Pull out the plug from the power connection before cleaning! Once per week - with frequent
use more often - carry out:
•
Clean the chill air openings
•
Blow out with dry pressure air the engine
•
Remove the floor covering leftovers
Caution!
Exchange the wear parts in time!
7.3 Changing the blade
Caution!
Danger of cutting for the hands! Wear protective gloves!
•
Unfasten the hexagonal nuts, key width 10mm, approx. half a rotation with the provided
double ring key.
•
Pull out the blade.
•
Insert the new blade with the phase upwards.
•
Fasten the hexagonal nuts.
7.4 Safety notes maintenance
Note!
For all works the following can be applied in general:
•
The works must be done by trained personnel only.
