Scannex ip.buffer User Manual
© UK 2007-2021 Scannex Electronics Ltd. All rights reserved worldwide.
4 . P h y s ic a l M o u n tin g
4.1. ip.1 – plastic box
4.1.1. DIN Rail Mounting
Fits “top-hat” DIN rail, as per DIN E0022, 35x15 or 35x7.5mm.
To fit:
●
Hang the ip.buffer onto the top lip of the DIN rail
●
Push the bottom of the box down onto the rail until it clicks into place
To remove:
●
Push box up and unhook from the top of the DIN rail lip.
4.1.2. Wall mounting
●
Mount two flat-headed screws (not supplied) that are 90mm apart in a vertical line
○
The stem should be no more than 4.5mm diameter
○
The screw head should be between 6mm and 11mm
●
Leave the heads proud of the wall
○
The head should be no more than 6mm from the wall
●
Slot the box onto the screws.
4.2. ip.4 – metal case
19” rack mounting:
●
Screw the two ears onto the sides of the casing, using the 6 screws provided.
●
Mount in a 1U rack position.
Page 12
Scannex ip.buffer User Manual
© UK 2007-2021 Scannex Electronics Ltd. All rights reserved worldwide.
4 . P h y s ic a l M o u n tin g
4.1. ip.1 – plastic box
4.1.1. DIN Rail Mounting
Fits “top-hat” DIN rail, as per DIN E0022, 35x15 or 35x7.5mm.
To fit:
●
Hang the ip.buffer onto the top lip of the DIN rail
●
Push the bottom of the box down onto the rail until it clicks into place
To remove:
●
Push box up and unhook from the top of the DIN rail lip.
4.1.2. Wall mounting
●
Mount two flat-headed screws (not supplied) that are 90mm apart in a vertical line
○
The stem should be no more than 4.5mm diameter
○
The screw head should be between 6mm and 11mm
●
Leave the heads proud of the wall
○
The head should be no more than 6mm from the wall
●
Slot the box onto the screws.
4.2. ip.4 – metal case
19” rack mounting:
●
Screw the two ears onto the sides of the casing, using the 6 screws provided.
●
Mount in a 1U rack position.
Page 12