Document type
Document number
Rev
Page
Manual
66024
C
19 of 37
3.6
Crane stop function box (optional)
The crane stop function box is a separate unit for fixed mounting on the vehicle (see
figure 3.10). The crane stop function box must be connected between the vehicle
battery and the central unit.
•
When the stop function is activated the main power supply to the entire remote
control system is disconnected.
•
The crane stop function must be suitably located and easily accessible.
•
Before operation is started, the driver must inform all fellow-workers about the
stop function and its location.
•
Crane stop function box is not a scope of delivery from Scanreco – it is the
installers responsibility.
With the central unit switch in MANUAL position and an electric dump valve, the stop
function is also available during manual hand lever operation. (See also chapter 4
"Safety regulations and Operating instructions").
Figure 3.10 Stop function box.
19/37
Summary of Contents for RC400
Page 1: ...Instruction Manual RemoteControlSystemRC400 Document 66024 Revision D Language English ...
Page 2: ......
Page 39: ......
Page 40: ......