COMPACT 75
COMPACT 75
Operator’s manual for drilling machine
- 11 -
7. INSTALLING AND UNINSTALLING THE MILLING CUTTER
Milling cutter installation and uninstallation should be carried out when
the machine is turned off and disconnected from the power grid!
Installing the milling cutter:
1.
Raise the drive and the slide (2) up using the lever (3);
2.
Raise the guard (1) to the maximum in order to attain access to the arbor (4) screws
(5);
3.
Insert the appropriate type of pilot (6) into the milling cutter (7);
4.
Position the milling cutter (7) with the cutter facing up, so that the flat sides of the milling cutter
are found facing the screws (5);
5.
Put the milling cutter (7) into the arbor socket (4);
6.
Tighten the screws securely (5).
Uninstalling the milling cutter:
1.
Raise the drive and the slide (2) up using the lever (3);
2.
Raise the guard (1) to the maximum in order to attain access to the arbor (4) screws
(5);
3. Loosen
the screws (5);
4.
Remove the milling cutter (7) and the pilot (6) from the arbor socket (4).
