COMPACT 75
COMPACT 75
Operator’s manual for drilling machine
- 12 -
8. MAGNETIC DRILLING MACHINE START UP
The machine is supplied in a metal box with complete standard equipment.
Before first drill:
•
Steel elements of the drilling machine are protected for transit and storing with grease film. Before
first start up of the machine all grease should be removed. This especially applies to Morse Taper.
•
Before each use all handles should be screwed into pinion.
Before setting the machine on an item make sure that:
•
Substrate is a steel and ferromagnetic (some of stainless steel or acid
-proof or do not conduct the
magnetic flux);
•
Thickness of work piece is at least 10 mm (3/8”);
•
Surface of steel under the magnet is flat;
•
Wipe, brush or sand down clean surface where you intended to place the drilling machine; so that
you remove rust, paint, dirt etc which would reduce adhesive power of the electromagnetic base.
Preparation the machine for drilling:
1. Set the drilling machine on the surface of the element which hole is to be drilled.
2.
Accurately and securely attach the drill spindle in the nest (see
3.
Plug in the drilling machine accordance to the requirements (see
4.
Set the axis of the spindle exactly over the place of drilling (the tool is over the centre of the hole).
5. Turn the magnetic base ON.
Prior to use!
Always make sure that the electromagnetic machine is secured from falling
down during vertical, ceiling work with original chain.
