MODEL MB-45
MODEL MB-45
Operator’s manual for Drilling Machine
- 16 -
3.
Operating instructions
The machine is supplied in a hard plastic suitcase. Steel elements of the drilling
machine are protected for transit and storing with grease film. Before first start up of the
machine all grease should be removed. Before each use all spoke handles should be
screwed into pinion.
Control panel includes below elements:
(1)
– Switch for drilling direction (Anticlockwise)
(2)
– Switch for drilling direction (Clockwise)
(3)
– Turnswitch for RPM
(4)
– START-STOP button MOTOR (start)
(5)
– START-STOP button MOTOR (stop)
(6)
– Fuse
(7)
– Main switch MAGNET
a) In order to start the machine press the main switch MAGNET (7
) on “I” button. Now you
can start the motor by pressing green button MOTOR (4).
b) Stopping the motor is executed with red button (5)
„O” (then the motor is switched
OFF but the electromagnetic base is still ON) (7).
c) To move machine into next drilling spot, stop the motor as described above and
push the mains switch (7) to the position
“O”.
d) To change the speed use the turn switch (3).
e) To change the direction of the motor to clockwise (2) or anticlockwise (1) press either I or
II on the button in the upper left corner of the control panel.
f) To change the fuse unscrew the cap (6), exchange the fuse and mount the cap in the
opposite direction of dismounting
Drawing 6. Control panel
