MODEL MB-45
MODEL MB-45
Operator’s manual for Drilling Machine
- 17 -
To move machine into next drilling spot, stop the motor as described above
and push the mains switch MAGNET
to the position “O”.
.
READ THE WHOLE INSTRUCTIONS MANUAL
BEFORE ATTEMPTING TO START UP
III. ADJUSTMENT, MAINTENANCE AND SERVICE
Every 50 hours of work, or as need arises, elimination of excess play in slide guides
should be performed. The screws are provided for that reason. Play in slide guides is
acceptable the slide goes up easily and does not slide down under its own weight. (see
paragraph II no.2.8)
Regularly check condition of carbon brushes. (see paragraph IV
– Technical data).
Lubricate regularly brass slide guide inserts with grease as well as the rack and pinion.
To prevent the machine from rusting (especially when used outdoors) all steel parts
should be covered with thin layer of grease film.
Damaged machine parts to be exchanged only to original parts.
Every repair work should be done only by authorized service points, appointed by
distributor.
New spare parts order: required to enter the code or send the damage part with
information about type of drilling machine and power supply.
