MODEL MB-45
MODEL MB-45
Operator’s manual for Drilling Machine
- 4 -
5)
In all cases always use a safety chain/strap /see drawing 1/. The safety strap mustn't
be loose! To avoid this situation the safety strap should be wrapped around the element
it is hooked to.
6)
Do not use the machine in explosion hazard zones.
7)
Do not start work if the machine has excessive play on guide slides.
8)
Always wear safety goggles and ear protection.
9)
Do not remove metal chips with bare hands.
Safety chain/strap can also secure the drill through
the handle
.
10) Do not touch the spindle and cutter during work.
11) Tools must be fastened firmly. When a milling cutter is used, check before start of work
if tool holding screws are screwed tight.
12) It is not permitted to use blunt of damaged tools.
13) Do not use milling cutter without pilots, and arbors without ejection spring.
Do not touch or replace the tool with power source on
– while
electromagnetic base is being used.
Drawing 1.
Examples on how safety chain/strap should be
fastened.
.
