Chapter 6: Troubleshooting
Lamps
Operator’s Guide
121
Lamps
Lamp warm up and shut off periods vary depending on
the software that you are using. See the table below:
NOTE:
If you wish to shut off the lamps sooner than 240
minutes after running a ScanTools Plus application,
simply run Click&Scan or SVT with the Power Saver
Device Setting set to the desired shut off time.
Software
Warm up
Shut off
• ScanTools Plus
• associated data collec-
tion diagnostic software
5 minutes
240 minutes
• Click&Scan
• Scanner Validation Tool
(SVT) document imag-
ing software
20 seconds
0 to 240 minutes based
on Power Saver setting
in Device Settings
Summary of Contents for iNSIGHT 30
