Chapter 4: Maintenance
Cleaning the Separator Module
80
Scantron
i
NSIGHT 30 Scanner
3.
Inspect the tires. If the separator module tires show
signs of wear or damage, replace the tires or the
separator module. See “Replacing the Separator
Module and Separator Module Tires” on page 90 for
procedures.
4.
Reinstall the separator module by aligning the shaft
ends and snapping it into position.
5.
Press firmly until the separator module clicks into
place.
6.
Lower the scanner cover and
press it down firmly
until it latches into place.
Shaft Ends
Summary of Contents for iNSIGHT 30
