Chapter 3: Installation
Getting Ready to Scan
Operator’s Guide
57
Getting Ready to Scan
Once the hardware is connected and the drivers are
installed, perform the following steps to prepare to scan
documents:
•
Step 1: Calibrating Your iNSIGHT 20 Plus (page
•
Step 2: Running the Document Imaging Test
If your scanner came bundled with ScanTools Plus data
collection software, perform the following three steps:
•
Step 3: Installing ScanTools Plus Software (page
•
Step 4: Configuring the Scanner (page
•
Step 5: Running the Data Collection Test (page
Step 1: Calibrating Your
i
NSIGHT 20 Plus
CAUTION:
The Calibration Utility should only be run for the
following reasons:
•
upon initial installation
•
you move the scanner to a different computer
•
your scanner is exchanged for a new one
•
you are directed to by Scantron support
NOTE:
You can run only one of the following programs at a
time because they use the same driver:
•
i
NSIGHT Scanner Utilities
•
Click&Scan
•
ScanTools Plus
The calibration program does two things to ensure that
the scanner will read production data collection forms
properly:
•
Checks the black, gray, and white areas of the
sheet to create a calibration table that maps the
256 gray levels to the 16 levels used for data col-
lection.
•
Targets the location of the black dots for
positioning purposes.
Summary of Contents for iNSIGHT 20 Plus
