Chapter 3: Installation
Getting Ready to Scan
62
Scantron
i
NSIGHT 20 Plus Scanner
13.
When verification is completed successfully, the
Calibration complete
dialog box appears. Click
OK
to continue.
NOTE:
To view information about the calibration, you
can view the calibration and log files located in the
Scanner folder on the root drive of your computer.
The files are named as follows:
•
Log files: <serial number>_20p_norm.log
•
Calibration files: <serial number>_20p_cal.lut
14.
Do one of the following:
•
To run a document imaging test, continue to “Step
2: Running the Document Imaging Test” on
•
To exit the
i
NSIGHT Scanner Utilities
installation, click
Finish
Step 2: Running the Document Imaging Test
NOTE:
You can run only one of the following programs at a
time because they use the same driver:
•
i
NSIGHT Scanner Utilities
•
Click&Scan
•
ScanTools Plus
Summary of Contents for iNSIGHT 20 Plus
