Mistral Operating Instructions
Part No. SCAZ037980 v6.0.2
26
E&OE
Operator’s routine maintenance
It is important that the following routine maintenance procedures are carried out as directed. This will help to ensure that your Scarab sweeper performs at the optimum level
of safety and efficiency. Refer to the paragraphs immediately following this schedule and to the Table of Contents for more detailed information.
Wear appropriate PPE.
It is vital that the water system is drained totally if the air temperature is
expected to fall to 0°C or below.
In frosty weather leave the hopper slightly raised with the rear and side door
partially open.
The foregoing are general recommendations only. Requirements vary from
territory to territory and depend on vehicle usage/operating conditions.
If in doubt consult your nearest dealer.
Item
Procedure
Daily actions
Before use / After use
Weekly
1
Check vehicle/body for safety. All lighting
equipment, tyres, fuel, oil, coolant, brake fluid,
windscreen wash and water tank level.
2
Check auxiliary engine, fuel, oil and coolant levels.
3
Check hydraulic oil level and inspect system for
signs of leaks. Check oil cooler is clean.
4
If vehicle not previously used by YOU, check
suction fan is clean.
5
Check brushes/skirts for wear or damage. Remove
entangled items, e.g. string are strapping. etc.
6
Check suction nozzle flaps for damage/correct
ground clearance.
7
Check water spray jets for blockages.
8
Check that all equipment is securely stowed and
brushes are retracted.
9
Wash vehicle, particularly hopper screen,
surrounding ledges and area above. Leave hopper
door partially open, to allow air to circulate.
10
Wash oil cooler, ensuring that the fins are clean.
11
1. Lubricate as appropriate, all brush links, pivots
12
Remove/clean the L-P and H-P water filter
elements.
13
Clean the suction fan thoroughly, using the
scraper provided and high pressure water (
See
Page 23
).
14
Conduct a thorough inspection of the fan
assembly to verify its condition. Report any
defects (
See Page 23
).
15
Grease prop-shaft and check wear of universal
joints (U/Js).
16
Grease hopper ram, top and bottom.
17
Visually check entire sweeper for wear/damage.
18
Check wiring and hoses for security of attachment
and signs of wear are damage.
19
Check wear in suction tubes and deflectors in
hopper.
20
Check seals on hopper door, rear hatch and
suction tubes.
21
Check oil level in H-P pump, top-up if needed.
22
Grease all points (
See Page 29
).
23
Check subframe to chassis fixing brackets.
Item
Procedure
Daily actions
Before use / After use
Weekly
Summary of Contents for Mistral
Page 42: ...Mistral Operating Instructions Part No SCAZ037980 v6 0 2 42 E OE Operator s notes ...
Page 43: ...Mistral Operating Instructions Part No SCAZ037980 v6 0 2 43 E OE Operator s notes ...
Page 44: ...Mistral Operating Instructions Part No SCAZ037980 v6 0 2 44 E OE Operator s notes ...
Page 45: ...Mistral Operating Instructions Part No SCAZ037980 v6 0 2 45 E OE Operator s notes ...
