TURNING THE UNIT ON/OFF
Turn on the system.
•
Press the ‘POWER’ button to switch on.
•
The red LED above the power button will turn on.
•
If a PIN is enabled, LED’s 1-4 will flash four times indicating that the system is locked.
•
Enter the correct PIN number, if incorrect, the system will shut down immediately.
•
The system will also shut down after 30 seconds if no PIN is entered.
Turn off system.
•
Press and hold the power button for 3 seconds until all number LED’s flash rapidly to
switch off.
•
If the system was in low power standby, the system will power up first, flash all
number LED’s rapidly then shut-down when the power button is released.
•
If a PIN is enabled, LED’s 1-4 will flash indicating that the system is locked.
•
Enter the correct PIN number, if PIN entered is correct, the system will shut down
immediately.
•
The system will remain on if the incorrect Pin was entered.
•
If the system was in low power standby, the system will power up first, flash LED’s
1 – 4 to prompt for the PIN entry.
Lock the system.
•
If PIN enabled and the system is unlocked, press the power button briefly to lock the
system, all number LED’s will flash and the system will be locked.
Note:
The system will lock itself after 15 minutes if no keys are pressed and the PIN is set and
enabled.
Unlock the system.
•
Assuming the unit is on, press and hold ‘N’ for 3 seconds and LED’s 1-4 will flash to
prompt PIN entry.
•
Enter the correct PIN number which will be confirmed by all the number LED’s
flashing twice. Incorrect pin will be indicated by all number LED’s lighting for two
seconds.
Cancel PIN entry mode.
•
Briefly press the Power button to exit PIN entry mode while LED’s 1 – 4 are flashing.
Page 11
