IM021
SC-JE50S47
5
Practice assembling and dismantling the unit a few times before making juice.
HOW TO ASSEMBLE
DISMANTLING:
Unplug the appliance from the power supply.
Open the locks.
Remove the transparent lid, pull the grating filter upwards, then take off separating unit. While doing
this, hold it by the beak from below and by the underside of the top of the unit on the other side.
ASSEMBLING:
Before assembling, make sure that the engine is turned off and the appliance is disconnected from the
mains.
Place the separating unit on the motor unit, push with both hands on the separating unit until it clicks
into place.
Insert the grating filter; turn it clockwise to fit securely.
Mount the transparent lid and fasten the locks.
Place the pulp container under the cover, and the glass
– under the beak for juice.
Plug the appliance to the power supply.
OPERATING INSTRUCTIONS
This appliance is equipped with a safety system. If the cover is not correctly placed or the locks are
unfastened, the appliance will not function.
Before starting make sure that the juicer is switched off and transparent lid fixed properly.
Wash fruits and vegetables thoroughly. Cut fruits into small pieces so as to be fitted into the feeding
tube. Remove the stone or peel from those citrus and fruit: prunes, apricots, cherries or oranges,
lemons, melons, etc.
Place a juice jug under spout.
Plug cord into the wall socket. Switch on the appliance and choose desired speed:
Speed I: for soft foods (pears, strawberries, oranges, plums, grapefruit, lemon, grapes, marrows and
pumpkins, cherries, onions, cucumbers, garlic).
Speed II: for hard foods (artichokes, carrots, fennel, apples, beets, potatoes, pineapple, cabbages,
leeks, celery, spinach).
P
– pulse mode of operation: the juicer works while the speed switch is held in the "P"position.
Feed the pre-prepared fruits and vegetables into the juice extractor and press down gently with the
pusher. NEVER USE FINGERS AS PUSHER.
The motor must always be running after fruit or vegetables were fed into the appliance.
When pulp container or juice jug is full, switch off the power and empty containers before continuing
the process.
CAUTION:
The juice extractor cannot process bananas, peaches, apricots, mangos, papayas, etc.
The juice extractor cannot process coconuts or other hard food.
When process is completed, switch off and unplug the unit.
CLEANING
Remove and wash all removable parts in warm soapy water. Rinse filter assembly from under side for
easy removal of residue from strainer holes. Do not use a dishwasher or very hot water.
Do not use steel woods, abrasive cleaners or scouring pad on appliance.
To clean the outside of the motor unit, use a damp sponge.
Never immerse the body in water.
Some vegetables, such as carrots, may cause discoloration of the plastic. Reduce this by washing
parts immediately after use with small amount of non-abrasive cleaner on a cloth, rub gently, then rinse
well and dry.
The grating filter must be replaced as soon as any signs of damage or wear and tear appear.
STORAGE
Store assembled cleaned and dried juice extractor in a dry place.
The symbol on the unit, packing materials and/or documentations means used electrical and
electronic units and should not be toss in the garbage with ordinary household garbage. These units
should be pass to special receiving point.
For additional information about actual system of the garbage collection address to the local authority.
Valid utilization will help to save valuable resources and avoid negative work on the public health and
environment which happens with incorrect using garbage.
