HDMI 1 in 4 out SPLITTER with IR extender
XHDM314
Email: support@kovert.com
Last Revised 01/06/2018
Installation
1. Connect an HDMI cable from an HDMI source (e.g MEGA DVR, DVD Player etc.) to the HDM314
Input. The maximum cable run from the HDMI source is 15m for a 1080P signal or 10m for 4K. If the
distance of the cable run needs to be longer, you can use an *HDM150 HDMI extender prior to and if
necessary following the HDM314. See test results on previous page.
2. Connect HDMI leads to Outputs 1 ~ 4 on the HDM314 with maximum run of 15 metres and connect
HDMI monitors/devices.
3. Set EDID dipswitch settings. All UP = 1080P
(set if all outputs are 1080P)
ALL DOWN = 4K
(set if all outputs are 4K)
DOWN,DOWN,UP,UP = EDID Copy
(set if all outputs copy input)
4. Connect the 5vDC 1A regulated power supply to the 2.1mm power jack socket.
5.
Using the IR remote facility
- optional
If you want to use the IR remote for example controlling the MEGA DVR, see below:
a) Ensure that the adaptor switch is correctly set to IR or CEC. IR is for controlling a standard IR
remote but a CEC IR remote can control multiple devices with the one control. Only one HDMI channel
can use the IR remote.
b) Connect the IR Adaptor into the HDMI connection on the monitor.
c) Connect the HDMI cable from the DVR HDMI output into the IR Adaptor detailed in b).
d) Connect the IR Receiver mini jack plug into the IR Adaptor and remove the cover from the sticky
pad and fix the IR Receiver to the monitor case so that it can be seen by the DVR IR remote controller.
e) Connect the IR Transmitter mini jack plug to the jack socket on the HDM314 and remove the cover
from the sticky pad and fix the IR Receiver to something facing the DVR IR sensor.
f) Now you can use the DVR IR Remote controller by pointing at the IR Receiver attached to the
monitor and you can control the DVR.
*
HDM150 Extender can be purchased to increase cable run to and from the HDM314 splitter.
Technical Specification for HDM314
HDMI Input
1
HDMI Version
HDMI 1.4
Cable Standard
28AWG HDMI 1.4
HDMI Output
4
Bandwidth
Up to 340 MHz
Power Consumption
2.5 watts max / 120mA
Input Video
0.5 – 1.0 v p~p
Signal Speed
Up to 10.2 Gbps
Power Supply
5v 1 amp
Input DDC Signal
5v p~p (TTL)
Input cable Length
15m 1080P / 10m 4K
Net Weight / Size
210g / 150x65x25mm*
HDMI connectors
19 pin HDMI 1A – ‘A’
Output cable Length
15m 1080P / 15m 4K
Operating Temperature
0°C ~ 70°C
Single Link Range
3840 x 2160
Input/Output Extender
HDM150 15m x 2
Special Features
IR control / EDID
*Size including mounting lugs is 167mm x 65mm x 25mm
All specifications are approximate. Kovert.com reserves the right to change
any product specification or features without notice. Whilst every effort is
made to ensure that these instructions are complete and accurate,
kovert.com cannot be held responsible in any way for any losses, no matter
how they arise, from errors or omissions in these instructions, or the
performance or non-performance of the camera or other equipment that
these instructions refer to.
