10
myScatterBox.com
Menu System
The MOD200 should be ready to use straight out of the box. You should only need to
amend the below settings when cascading multiple MOD200s, when channel band 60
clashes with channels used in the local area or if you wish to change the channel name.
Service Name
Default - AlienDVR.
This is the channel name as it will appear in the program guide on the TV.
If the MOD200 isn’t being used to connect an AlienDVR but some other equipment such as Sky
box you can change the service name to suit.
Provider Name
Default - AlienDVR.
This is the name of the channel provider e.g. BBC, BSkyB. This could be
changed to the company installing or supplying the equipment or even a contact telephone
number for the installer.
LCN (Logical Channel Number)
Default - 800.
This will be the channel number on the TV. If you are using more than one MOD200
as shown on page 6 then each additional unit will need a different LCN e.g. 801, 802 etc.
Frequency
Default - CH60 786.00 MHz.
This may clash with TV channels in the local area. If you are using
more than one MOD200 as shown on page 6 then each additional unit will need a different
channel e.g. CH61, CH62 etc. (depending on channel used in the local area)
RF Level Adj.
Default - -30Db.
This normally works okay when you are inputting a strong HDMI signal.
However if longer runs are involved you may need to reduce this setting.
Password
Default - 0000.
When accessing the menu system you will be asked to input your password.
0000 is displayed by default so if you haven’t changed the default password you can simply
press the ‘
OK
’ button. If you have previously set a password simply use the arrow buttons to
select and change digits then press the ‘
OK
’ button.
