Modules
6 - 16 Setting Up SATA RAID or AHCI Mode
6
SATA RAID Setup - UEFI Disabled
To configure your RAID (Redundant Array of Independent Disks) system in Strip-
ing (RAID 0) or Mirroring (RAID 1) modes (see
Table 6 - 1, on page 6 - 3
) you will
require
two
identical
hard disks or solid state drives.
You need to setup a RAID before installing your
Windows 10
operating system, and
you will need to prepare the following in order to do so.
==========================================================
• The
Microsoft Windows 10 OS DVD
.
• An attached external DVD drive.
• A hard disk installed in the Primary HDD bay and a
second
(identical) hard disk
installed in the Secondary HDD bay.
OR
Two Identical solid state drives.
• The
Device Drivers & Uti User’s Manual
disc.
==========================================================
1.
Start-up your notebook computer and press <F2>
to enter the
BIOS
.
2.
Go to the
Boot
menu, select
UEFI Setting
and press <Enter> (see page
5 - 18
).
3.
Set
UEFI Boot
to “
Disabled
”.
4.
Press <Esc> to exit the menu and go to the
Advanced
menu.
5.
Select
SATA Mode
(see page
5 - 12
), press <Enter> and select “
RAID Mode
”.
6.
Press <F4> and <Yes> to “
Save Changes and Reset
”.
7.
As the computer restarts press
Ctrl + i
to enter RAID configuration menu.
Summary of Contents for XMG U726
Page 1: ...V15 1 00...
Page 2: ......
Page 20: ...XVIII Preface...
Page 212: ...Modules 6 72 6...
