www.scheppach.com
28 | GB
15. Troubleshooting
Problem
Possible cause
Help
Motor doesn’t start
a)
ON/OFF switch damaged.
b)
ON/OFF cable damaged.
c)
ON/OFF relay damaged.
d)
Fuse blown.
e)
Motor burnt.
a-d)
Replace all damaged parts
before you use your machine
again.
e)
Contact your local service cen-
tre. Every attempt to carry out a
repair, can be dangerous if it is
not done by skilled personnel.
Machine gets slower
during work.
Too much pressure put on the
workpiece.
Reduce the pressure on the workpiece.
Sanding belt comes
off the drive pulleys.
Belt does not run straight.
Reset the track.
The wood gets burnt
during sanding.
a)
Sanding disc or belt covered
with grease.
b)
Excessive pressure on
workpiece.
a)
Replace disc or belt.
b)
Reduce pressure on workpiece.
Summary of Contents for 4903302901
Page 2: ...www scheppach com 2 12 1 2 7 3 14 5 13 11 9 10 8 6 4 15 16 1 14 14 1 17 7 1 2 3 4 5...
Page 3: ...www scheppach com 3 5 20 17 15 16 1 14 20 18 19 10 6 6 7 8 9 10 11 12 13...
Page 4: ...www scheppach com 4 X W W R W 7 0 15 45 max 1 6 mm 3 6 14 13 14 15 16 17 18 19...
Page 86: ...www scheppach com 86...
