27
GB
www.scheppach.com /
service@scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
www.scheppach.com /
service@scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
•
The dust produced when using this tool
may be harmful to health. Do not inhale
the dust. Use a dust absorption sys-
tem and wear a suitable dust protection
mask. Remove deposited dust thorough-
ly, e.g. with a vacuum cleaner.
•
Always keep the connection cable from
the working area of the device. Always
guide the cable backwards, away from
the device!
•
Do not machine any materials that pres-
ent a danger to health (e.g. asbestos).
•
When working in walls ceiling, or floor,
take care to avoid electric cables and gas
or waterpipes.
•
Please turn the device immediately off
when the tool used gets blocked! Do not
turn the device on again when the tool
is still blocked. This could cause bounce
back with a high reaction moment. Deter-
mine and remove the cause of the block-
ing of the tool used while respecting the
safety instructions.
The possible causes may be:
•
it is tilted in the workpiece to be ma-
chined
•
it has pierced through the material to
be machined
•
the power tool is overloaded
•
Do not reach into the machine while it
is running.
•
Chips and splinters must not be removed
while the machine is running.
WARNING! Danger of burns
The insertion tool may become hot during
use.
•
when changing tools
•
when setting the device down
Warning!
This electric tool generates an
electromagnetic field during operation. This
field can impair active or passive medical
implants under certain conditions. In order
to prevent the risk of serious or deadly in-
juries, we recommend that persons with
medical implants consult with their physi-
cian and the manufacturer of the medical
implant prior to operating the electric tool
Technical data
Blow rate min
-1
: 2000
Dimensions
L x W x H mm:
652 x 157 x 276
Blowing force Joule:
50
Weight kg:
16
Motor V/Hz:
230 V~ / 50 Hz
Power consumption
P1 W:
1600
Protection class:
II
Type of Protection:
IP20
Tool fitting:
SDS-HEX
System 30 mm
Technical modifications subject to change!
Sound and vibration
Sound and vibration values were measured
in accordance with EN 60745.
