Scheppach 5808802903, Translation From The Original Instruction Manual

17

Throttle control

It controls engine speed. Put the throttle control on low 
speed (L) or high speed (H) or an intermediary position 
between L and H to increase or decrease the speed of 
engine.

Left steering lever

Operate the lever to turn left.

Right steering lever

Operate the lever to turn right

Gear selection lever

It controls forward or reverse movements of the ma-
chine.

Tipping handle

Pull the locking plate to the direction A with the left hand 
and unlock the tipping handle.
To raise the dump box, pull the tipping handle up to the 
direction B with the right hand. The hydraulic system op-
erates, raising the dump box by hydraulic cylinder. When 
the dump box is raised to the expected position, pull the 
tipping handle back to its original position and lock it with 
the locking plate securely, otherwise the dump box will 
reach its maximum.
To lower the dump box, pull the tipping handle down to 
the direction C with the right hand. The hydraulic system 
operates, lowering the dump box by hydraulic cylinder. 
When the dump box is lowered to the original position, 
pull the tipping handle back to its original position and 
lock it with the locking plate securely.

Let the lever go in time when the transport tray is in the 
end positions. Otherwise, you risk overloading of the 
hydraulic system.

Motor

Engine components Figure 7-8

1.  Throttle
2.  Exhaust
3.  Spark
4.  Air Filter
5.  Petcock
6.  Choke lever
7.  Reversiestarter
8.  Recoil
9.  Ignition switch
10.  Gas cap
11.  Fuel tank
12.  Oil drain plug
13. 

Oil filler / dipstick

Minitransporter Operation

Adding fuel

Fill the only clean fuel with min. 90 octane and max. 5% 
bio-ethanol content in the fuel tank.

m

 Fill tank to no more than 12.5mm (1/2”) below 

the  bottom  of  the  filler  neck  to  provide  space  for 

expansion.

When tipping the load from a dumper, the centre of grav-
ity will change continuously and the ground conditions 
will be essential for the stability of the machine. There 
are special hazards for dumpers working on soft ground 
and when the load is sticking to body e.g. wet clay. 

Contents supplied, Fig. 1

The all terrain minitransporter comes partially
assembled and is shipped in carefully packed
package. After all the parts have been removed
from the package, you should have:
1.  Main Frame
2.  Box
3.  Operator’s Manual
4.  Hardware Bag, including

Assembly, Fig. 2

Following the assembly directions below, you will as-
semble the machine in a few minutes.

Position the bottom panel inside the mounting bracket. 
Align the holes with the mounting bracket. Insert a bolt 

through holes and secure each side with a flat washer 

and a nut.

Engine oil

m

 Oil has been drained for shipping. Failure to fill 

engine sump with oil before starting engine will re-
sult in permanent damage and will void engine war-
ranty.

Fill with engine oil according to the maintenance sched-
ule.

Features and Controls Fig.3-4

1.  Throttle Control
2.  Engine Switch
3.  Right Steering Lever
4.  Clutch Control Lever
5.  Left Steering Lever
6.  Tipping Handle
7.  Gear Selection Lever
8.  Dump Box
9.  Gearbox
10.  Track

Engine switch

The engine switch enables and disables the ignition sys-
tem. The engine switch must be in the ON position for 
the engine to run. Turning the engine switch to the OFF 
position stops the engine.

Clutch control lever

Squeeze the control lever, clutch engaged. Release the 

lever, clutch disengaged.