www.scheppach.com /
service@scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
22 |
GB
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author
-
ised collecting point for the recycling of waste elec
-
trical and electronic equipment. Improper handling
of waste equipment may have negative consequenc
-
es for the environment and human health due to po
-
tentially hazardous substances that are often con
-
tained in electrical and electronic equipment. By
properly disposing of this product, you are also con
-
tributing to the effective use of natural resources.
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body
for the disposal of waste electrical and electronic
equipment or your waste disposal company.
Storage
m
Important!
Pull out the mains plug and ventilate the equip-
ment and all connected pneumatic tools. Switch
off the compressor and make sure that it is se-
cured in such a way that it cannot be started up
again by any unauthorized person.
m
Important!
Store the compressor only in a dry location
which is not accessible to unauthorized persons.
Always store upright, never tilted!
Storage power cord, hose and accessories (Fig. 2)
•
The power cord can be stored sideways of the com
-
pressor.
•
The air hose can be stored in the tool compartment.
11. Transport
•
The unit can be transported with the handle (1)
(fig. 5).
12. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip
-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
13. Troubleshooting
Fault
Possible cause
Remedy
The compressor does not start.
•
No supply voltage.
•
Insufficient supply voltage.
•
Outside temperature is too low.
•
Motor is overheated.
•
No supply voltage.
•
Insufficient supply voltage.
•
Outside temperature is too low.
•
Motor is overheated.
The compressor starts but there
is no pressure.
•
The non-return valve leaks.
•
The seals are damaged.
•
The non-return valve leaks.
•
The seals are damaged.
The compressor starts, pressure
is shown on the pressure gauge,
but the tools do not start.
•
The hose connections have a leak.
•
A quick-lock coupling has a leak.
•
The hose connections have a leak.
•
A quick-lock coupling has a leak.
Summary of Contents for 5906126901
Page 2: ...www scheppach com service scheppach com 49 08223 4002 99 49 08223 4002 58 2...
Page 139: ...www scheppach com service scheppach com 49 08223 4002 99 49 08223 4002 58 139...
Page 140: ...www scheppach com service scheppach com 49 08223 4002 99 49 08223 4002 58 140...
Page 142: ...www scheppach com service scheppach com 49 08223 4002 99 49 08223 4002 58 142...
