www.scheppach.com
GB
| 37
that the blade continues to rotate for a few seconds
after the engine has been switched off. Never attempt
to manually stop the blade. Regularly check to see if
the blade is securely attached, is in good condition
and is sharp. If the contrary is the case, sharpen the
blade or replace it. In the event that the blade strikes
an object,immediately switch off the lawn mower
and wait for the blade to come to a complete stop.
Then inspect the condition of the blade and the blade
mount. Replace any parts that are damaged.
Tips for proper mowing:
• Pay attention to ensure that you do not run into or
over anything that could damage the mower. The
lawn mower could be damaged and/or the machine
could inflict bodily injury.
•
A hot engine, exhaust or drive unit can burn the
skin if touched. Thus, do not touch these parts un
-
less the mower has been switched off for a while
and you know that they have cooled down!
•
Use extra caution when mowing on inclines and
steep grades.
•
Insufficient daylight or even a sufficient level of arti
-
ficial light is one reason not to mow.
•
Check the mower, the blade and other parts if they
have struck a foreign object or if the machine vi
-
brates more than usual.
•
Do not make any adjustments or repairs until the
engine has been switched off. Pull the plug boot.
•
Pay special attention if you are mowing directly
next to a street or are close by one (traffic). Always
keep the grass chute pointed away from the street.
•
Avoid mowing in places where the wheels have
trouble gripping or mowing is unsafe in any other
way. Before you back up, ensure that nobody is
standing behind you (especially little children, who
are more difficult to see).
•
When mowing over thick, high grass, select the
highest cutting level and mow at a slower speed.
Before you remove any grass or blockages of any
kind, switch off the engine and pull the plug boot.
•
Never remove any safety-related parts.
•
Never fill the engine with petrol when it is hot or is
running.
Emptying the grass basket
The debris bag (16) is equipped with a filling level in
-
dicator (Fig. 16). This will be opened by the air current
produced by the mower. If the flap falls during mow
-
ing, the debris bag (16) is full and should be emptied.
To ensure that the filling level indicator works prop
-
erly, the holes under the flap must be kept clean and
permeable.
As soon as grass clippings start to trail the lawn mow
-
er, it is time to empty the grass basket.
Tips for proper mowing
m
CAUTION! Never open the chute flap when the
catch bag has been detached (to be emptied) and
the engine is still running. The rotating blade can
cause serious injuries!
Always carefully fasten the chute flap and grass bas
-
ket. Switch off the engine before emptying the grass
basket.
Always ensure that a safe distance (provided by the
length of the long handles) is maintained between the
user and the mower housing. Be especially careful
when mowing and changing direction on slopes and
inclines. Maintain a solid footing and wear sturdy,
non-slip footwear and long trousers. Always mow
along the incline (not up and down).
For safety reasons, the lawn mower may not be used
to mow inclines whose gradient exceeds 15 degrees.
Use special caution when backing up and pulling the
lawn mower. Tripping hazard!
Mulching
In the mulching mode the cuttings are shredded in
the enclosed mower housing and then spread back
onto the lawn. It is not necessary to gather and dis
-
pose of the grass.
m
Note!
Mulching is only possible if the lawn is rel
-
atively short.
To use the mulching function, disconnect the debris
bag (16), slide the mulching adaptor (Fig. 10-12 / pos.
19) into the ejector opening and close the ejector
opening (15).
Mowing
Mowing can either take place with the grass box (16)
attached or using the side discharge (8) When using
the side discharge, the mulch insert (19) should be at
-
tached.
Only use a sharp blade that is in good condition.
This will prevent the grass blades from fraying and
the lawn from turning yellow. Try to mow in straight
lines for a nice, clean look. In doing so, the mowing
swaths should always overlap each other by a few
centimeters in order to avoid bare strips.
Keep the underside of the mower housing clean and
remove grass build-up. Deposits not only make it
more difficult to start the mower; they decrease the
quality of the cut and make it harder for the machine
to bag the grass. Always mow along inclines (not up
and down). Slightly turning the front wheels up the hill
while mowing will prevent the mower from sliding out
of the straight line. Select the cutting height according
to the length of the grass. If the lawn has grown quite
a bit, mow over it several times so that no more than 4
cm of grass are cut at one time. Switch off the engine
before doing any checks on the blade. Keep in mind
Summary of Contents for 5911244903
