www.scheppach.com
32 | GB
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol
-
lowing parts are therefore also required for use as
consumables.
Wear parts*:
spark plug, air filter, petrol filter, knife,
belt
* Not necessarily included in the scope of delivery!
10. Storage
• Never store the mower (with petrol in the tank) in-
side a building in which petrol fumes could come
into contact with open flames or sparks.
•
Allow the motor to cool before you put the lawn
mower in an enclosed area.
•
In order to avoid fire hazards, keep the engine, ex
-
haust and the area around the fuel tank free from
grass, leaves and leaking grease (oil).
Preparing the mower for long-term storage
Caution: Do not empty the petrol tank in enclosed
areas, near fire or when smoking. Petrol fumes can
cause explosions and fire.
•
Empty the petrol tank with a petrol suction pump.
•
Start the engine and let it run until any remaining
petrol has been used up.
•
Change the oil at the end of every season. To do
so, remove the used engine oil from a warm engine
and refill with fresh oil.
•
Remove the spark plug from the cylinder head. Fill
the cylinder with approx. 20 ml of oil from an oil can.
Slowly pull back the starter handle, which will bathe
the cylinder wall with oil. Screw the spark plug back
in.
•
Clean the cooling fins of the cylinder and the hous
-
ing.
• Be sure to clean the entire machine to protect the
paint.
• Store the machine in a well-ventilated place.
Preparing the mower for transportation (Fig. 22)
•
Empty the petrol tank.
•
Always let the engine run until it has used up the
remainder of petrol in the tank.
•
Empty the engine oil from the warm engine.
• Remove the spark plug boot from the spark plug.
•
Clean the cooling fins of the cylinder and the hous
-
ing.
• Remove the start tension cable (17) from the hook.
Loosen plastic star grip nut (5) and fold the upper
push bar down. Make sure the cables are not bent
during this process.
•
Wedge a few layers of corrugated cardboard be
-
tween the upper and lower push bars and the en-
gine in order to prevent any chafing.
11. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip
-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
Summary of Contents for 5911255903
