www.scheppach.com /
service@scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
GB
| 53
Putting the saw back into operation
•
Remove spark plug.
•
Pull starter rope briskly to clear excess oil from
combustion chamber.
•
Clean the spark plug and check that the electrode
gap is correct.
•
Prepare unit for operation.
•
Fill fuel tank with proper fuel / oil mixture.
12.
Transport
To transport the chain, empty the fuel tank. Remove
coarse dirt from the saw with a brush or a hand
brush.
14.
Troubleshooting
Problem
Probable cause
Corrective Action
Unit wonʼt start or starts but
will not run.
Incorrect starting procedures.
Follow instructions in the User Manual.
Incorrect carburetor mixture
adjustment setting.
Have carburetor adjusted by an Authorized
Service Center.
Fouled spark plug.
Clean / gap or replace plug.
Fuel filter plugged.
Replace fuel filter.
Unit starts, but engine has low
power.
Dirty air filter.
Remove, clean and reinstall filter.
Incorrect carburetor mixture
adjustment setting.
Have carburetor adjusted by an Authorized
Service Center.
Engine hesitates.
Incorrect carburetor mixture
adjustment setting.
Have carburetor adjusted by an Authorized
Service Center.
No power under load.
Incorrectly gapped spark plug.
Clean / gap or replace plug.
Runs erratically.
Incorrect carburetor mixture
adjustment setting.
Have carburetor adjusted by an Authorized
Service Center.
Smokes excessively.
Incorrect fuel mixture.
Use properly mixed fuel (40:1 mixture).
Poor performance when
operated
Blunt chain
Loose chain
Sharpen or replace the chain
Tension the chain
Engine dies
Empty petrol tank
Fuel filter in the wrong position in
the tank
Fill up the petrol tank
Completely fill the petrol tank or or re-position
the fuel filter in the petrol tank
Insufficient chain lubrication
(the cutter rail and chain get
hot)
Empty oil tank for the chain
Top up the oil tank for the chain
Oil lubrication openings moved
Clean the oil lubrication hole in the cutter bar
Clean the groove in the cutter bar
15.
Admitted saw chain and chain bar combination
Saw chain
Oregon
21BPX078X
Guide bar
Oregon
208PXBK095
13.
Disposal and recycling
The unit is supplied in packaging to prevent its be-
ing damaged in transit. This packaging is raw materi-
al and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic. De-
fective components must be disposed of as special
waste. Ask about recycling in the store or in the local
municipal administration!
Summary of Contents for CSP5300
