Scheppach FS85000, User Manual

13

45° diagonal cutting (Fig. 8)
1 

Set angled stop (6) to 45°

2 

Carry out cutting as described.

45° longitudinal cutting, (Fig. 9)
1 

Loosen the star knob screw (E) on both sides

2 

Slant guide rail (8) at the left to 45° of the angle 
scale (18).

3 

Tighten the star knob screw (E) again.

4 

Perform cutting as described.

Changing diamond cutting disc (Fig. 10- 11)
Caution! Disconnect power plug
1 

Loosen the 2 bolts (F) and take out the saw blade 
protection (20). (Fig.10)

2 

Place the wrench (21) on the motor shaft and keep 
it there. 

3 

Loosen the flange nut in the running direction of the 
cutting disc (10) with the wrench (22). 

4 

Remove the outer flange (23) and cutting disc (10). 
(Fig.11)

5 

Clean the supporting flange carefully before installing 
the new cutting disc.

6 

Insert the cutting disc in the reverse sequence and 
tighten it.

Caution: 

Pay attention to the running direction of the cut-

ting disc!

7 

Reinstall the saw blade protection (20).

Transport

Caution! Disconnect power plug

To transport the machine, set the machine head in front 
and engage the locking pin (13) (Fig.5)

m 

 Electric connection

Check electric cables regularly for damage. Ensure that 
during the check, the connecting cable is not connected 
to the mains.
Electric connecting cables must conform to the common 
VDE- and DIN provisions. Only use connecting cables 
with the H 07 RN designation.
Keeping a copy of the type designation on the connecting 

Fig. 8

6

Fig. 9

6

8

18

E

Fig. 10

F

F

Fig. 11

21

22

23