Scheppach FS85000, User Manual

14 

cable is a specification

DAMAGED ELECTRIC CONNECTING CABLES

Insulation damages frequently occur on electric connec-
ting cables. The reasons are:
•  Pressure points, if connecting cables are routed 

through window or door gaps.

•  Kinks due to improper mounting or routing of connec-

ting cables.

•  Intersections due to overruns of connecting cables.
•  Insulation damage due to pulling out from wall so-

ckets.

•  Cracks due to ageing of insulation.
Such damaged electric connecting cables should not be 
used and can be fatal because of the insulation damage

AC motor 230 V/ 50 Hz

Mains voltage 230 Volt / 50 Hz.
Mains connection and extension cable must have 3-wires 
= P + N + SL. - (1/N/PE).
Extension cables must have a minimum cross-section of 
1.5 mm².
The mains connection is secured with a max. 16A fuse.

Maintenance

Caution! Pull out power plug.

•  Clean the machine after each work cycle.
•  Replace worn out cutting discs.
•  Replace damaged protection device
•  Dust and pollution must be removed regularly from the 

machine. The best way to clean the machine is with a 
piece of cloth or brush.

•  All moveable parts must be re-lubricated at periodic 

intervals.

•  Do not use any corrosive substances to clean the plas-

tic.

•  The tub (4) and coolant pump (14) must be cleaned 

regularly to remove dirt, as otherwise the cooling of the 
diamond cutting disc (10) is not guaranteed.

Spare-part ordering

Please quote the following in your order for spare parts:
•  Type of device
•  Article No. of device
•  Ident. No. of device
•  Spare Part No. of the required spare part