17
Error messages will disapear immediately from the display when the control level is released or the fault
is eliminated. This means no waiting times for a restart.
Exception: If the table top model is used without a footswitch reset of the error messages by simultaneously
press and hold the reset touch fields Menu + + . A full reset can be done by pressing the touch fields
+ for 2 sec., or by disconnecting the mains supply.
If an error cannot be removed following the above description, please contact an authorised service partner
or Schick directly.
13. Possible error messages
The
control unit has an intelligent control electronics system which
recognises possible defects and can display them with an error code on the control unit.
If there is a defect, this is shown with a flashing red light on the controls satellites, with a flashing red
SCHICK-logo on the
control unit and with an error message with the following format
"E xxyy".
Example:
Error code: E 0201 - no motor connected
Error code
Error description
Error removal
E 0201
no motor connected
Check whether handpiece is corr ectly connected
(motor output 1 / motor output 2)
E 0801
motor overload
reduce pressure to the tool
E 0802
cable break
Remove motorcable
motor blocked
Check if chuck is closed, make sure that the shaft can be
easiliy moved
general
errror
unit flashes red, no display at the
satellite
Check cabel satellite
general
error
switching off by control satellite not possible.
Bad response of
Touchfields
+
Full reset by disconnecting from mains plug. Don‘t touch
satellite while restarting the unit.
general
error
chuck cannot be opened / tools are blocked
Make sure that the compressed air supply deliveres a
minimum of 87 psi
13.1 Reset after error message
