2
Index page
1. Safety information...............................
Caution!
2. Range of applications..........................
3. Summary
units.........................
4. List of contents - accessories................
spare parts
5. Initial start-up and installation
switching on and off............................
6
7.
8. Operation of touch-sensitive surfaces..
9. Basis and additional functions.............
10. Menu structure and basic settings.......
11. Speed control functions......................
12. Connecting and controlling a second..
motorhandpiece
13. Cleaning and Maintenance/.................
removing the chuck
14. Possible error messages.......................
Reset after error message
17.
....................
. Controls satellite..................................
Tool change on motorhandpiece..........
15. Suggestions for wax knife...................
16. Technical Data.....................................
Declaration of conformity
1. Safety information
1.1 Ascertain that your mains supply coincides
with the data on the rating plate.
1.2
- units are not suitable for the
following applications:
- in areas where there is a risk of explosion
- for medical applications
- for working on moist materials
1.3 Ensure that all regulatory requirements are
observed during use
- always wear protective glasses
- provide enough light at the working place
- use dust suction
1.4 Under no circumstances should the
motor handpiece be cleaned with
compressed air.
1.5 Before putting the handpiece down, always
insert a rotary instrument or the pin, supplied
with the unit, into chuck.
Caution:
- When using rotary instruments, do not
exceed the maximum speeds laid down by
their manufacturer.
- When operation with left-hand rotation, the
collet may loosen when there is a high load.
- Repairs and other technical procedures must
only be carried out by suitable qualified
personnel, authorized by SCHICK.
- SCHICK do not guarantee the
unit
should it not have been used in accordance
with the operating instructions.
2.Range of applications
The
unit is designed for universal use in
dental laboratories when trimming crowns and
bridges, respectively acrylic and light chrome cobalt
dentures. With its speed range from
200 - 60.000 rpm the SCHICK
- unit allows
to work all dental materials.
The motorhandpiece is ergonomical, small shaped
and runs smoothly, thus eliminating user-fatigue
and making it economical to use over long periods.
The progressive processor controller constantly
monitors the unit for overloading. A second
thermal fuse, which is independent of the
computer, provides further protection. Thus the
- unit offers a maximum of safety.
Conditions of environment:
- interior 5° - 40° C.
- up to 2,000 meter over sea level
Categorie of overvoltage: II
Grade of pollution: 2
WEEE-Reg.-Nr. DE 78620387
We are pleased that you decided
to buy a highly developed piece of
equipment from SCHICK and
would like to wish you every
success when working with your
new
control unit.
We wrote these operating
instructions to enable you to get
accustomed to your new piece of
equipment and to provide you
with the correct operating and
maintenance instructions.
2
2
3
4
5-6
7
8
9
9-11
11-14
15
15
16-17
18
18
18
19
20
